Latex rubber is a popular choice for making both molds and casts. Latex has several useful properties and it is also relatively easy to make both latex molds and casts by following the right procedures.
Liquid latex rubber is a versatiles material that is considered tough, durable and economical as well. It lends itself well for various applications in the fields of mold making and casting.
Latex molds capture details well and are usually used to make plaster and resin casts. They are also handy for casting abrasive materials like concrete as the mold will not tear despite the coarseness. The latex can also be applied on architectural details on the walls or even ceilings without the latex running off. This works especially well for making molds for restoration works.
Latex casting is usually used for making hollow molded rubber articles, toys, balls, imitation pottery, display items and flexible props. Liquid latex is popularly used for mask making as well as special effects works like wrinkles, scars and gashes for theatre, television and films. It is even commonly used as an adhesive for bald caps.
Apart from this, latex is useful for slushing casting clays for ceramic works and for coating polystyrene and other fabrics and even tools. This forms a protective and water proof coating on the items. It even allows for better handling and insulation for the tools.
Liquid latex rubber is a versatiles material that is considered tough, durable and economical as well. It lends itself well for various applications in the fields of mold making and casting.
Latex molds capture details well and are usually used to make plaster and resin casts. They are also handy for casting abrasive materials like concrete as the mold will not tear despite the coarseness. The latex can also be applied on architectural details on the walls or even ceilings without the latex running off. This works especially well for making molds for restoration works.
Latex casting is usually used for making hollow molded rubber articles, toys, balls, imitation pottery, display items and flexible props. Liquid latex is popularly used for mask making as well as special effects works like wrinkles, scars and gashes for theatre, television and films. It is even commonly used as an adhesive for bald caps.
Apart from this, latex is useful for slushing casting clays for ceramic works and for coating polystyrene and other fabrics and even tools. This forms a protective and water proof coating on the items. It even allows for better handling and insulation for the tools.
How to do?
It is easy to use latex rubber for making molds and casts. The most common method is dipping for mold making and pouring for casting - No elaborate process or expensive molds are required.
Latex molds are created by dipping the model directly into the latex rubber itself. Simply dip the model into the container to get a uniform coating and then let it dry. Repeat the procedure 10 to 12 times to build up the adequate thickness. Alternatively, the latex can also be painted on the model multiple times, while allowing each subsequent coat to dry properly.
The procedure for making latex casts is also quite similar. Here, the latex rubber is poured into the mold and allowed to sit for some time. Then the rubber is poured out again. A thin film gets deposited on the inner side of the mold and will dry to form a flexible cast. Keeping the latex inside for a longer time or repeating the procedure will increase the thickness of the latex cast.
Usually plaster molds are preferred for making latex castings. This is because the porous plaster will absorb the water in the latex and allow it to cure to form a cast. Therefore, latex and other molds are generally not preferred for latex casts.
Demolding liquid latex molds and casts is also simple as they can be easily peeled off the model or mold. However, it is advisable to dust the latex surface with talcum powder before demolding, else the latex will stick to itself. Latex casts can be painted with special latex paints to get the desired finish.
0 Response to "Making Latex Molds and Casts"
Post a Comment